VBOX 3iSL Betriebsanweisung PDF herunterladen (Seite 38)

VBOX 3iSL User Guide

Page 38 of 53

11/04/2012

Hardware configuration

First the VBOX 3iSL needs to be configured to use the IMU data from the IMU it is connected to.

1. Connect the IMU to the CAN port of the VBOX 3iSL with the required cable and power the VBOX 3iSL.

2. Open VBOX Tools and connect the computer to the VBOX 3iSL using either serial, USB or Bluetooth.

3. 

COM port number.

4. 

5. -

been correctly detected by the VBOX 3iSL.

6. 

7. to the CAN port that the IMU is

connected to.

8. Exit setup, then re-enter. This should correctly detect the presence of the IMU data should the ports

have previously been swapped.

NB: If the IMU tab has still not appeared under channels, the IMU settings should be checked to

make sure it is transmitting data at the correct baud rate and is configured correctly. If the LED

above the CAN port is not lit green the CAN messages from the IMU are not being understood by

the VBOX 3iSL and it is likely the IMU configuration is incorrect.

1 2 ... 33 34 35 36 37 38 39 40 41 42 43 ... 52 53

Keine Kommentare

VBOX 3iSL Betriebsanweisung Seite 38